G 8182/9

For use on all Numerically Controlled (NC) machines, machining centres and EDH EDM machines (vertical and horizontal) Suitable for rapid zero-setting in all three axes (x, y and z), determining work piece zero points, measuring work piece lengths or heights, determining bore centres, determining and/or correcting work piece deviations Robust, high-quality aluminium die-cast housing with active shock protection thanks to special gear mechanism (patented) - Steel coupling shank Ø 16 mm h5 Protection rating IP67 (against dust penetration and the effects of temporary immersion) Quick-change stem with threaded connection to preventing accidental dropping, and calibrated release mechanism to avoid to damaging the internal mechanisms, the touch probe or the work piece if the full scale is exceeded. Calibrated by means of 2 screws positioned at 90° to each other With individual identification number

Replacement rods with taper coupling, for older probe versions